Below are the faults people most often look for bike repair for. Prices are approximate and listed without parts; we give the exact amount after inspecting the bike.
016 €
The bike brakes poorly or the brakes squeal
WhyMost often the brake pads are worn, the cables and housing are stretched, or the caliper or V-brake setup has shifted. Squealing is sometimes caused by grease or dirt on the disc or rim.
Check it yourselfLook to see whether the friction layer of the pads is still visible. Wipe the disc or rim with a clean cloth. If the brakes work poorly or the lever pulls almost to the handlebar, don’t ride – bring the bike in.
What we doWe adjust the brakes and, if needed, replace the pads, cable or housing. Read more on the brake adjustment and repair page.
0213–15 €
Hydraulic disc brakes feel spongy or the lever „goes to the bar”
WhyAir has got into the hydraulic system, or the fluid is old. The pads may also be worn or the disc may be bent.
Check it yourselfCheck whether there are any traces of fluid under the hose. If you see a fluid leak, don’t ride.
What we doWe bleed hydraulic brakes and adjust the caliper; if the system is damaged, we replace the hydraulic brake.
03from 6 €
Gears skip, won’t engage or crackle
WhyMost often it’s stretched cables and housings, a bent derailleur hanger, or a worn chain. Sometimes the sprockets wear out together with the chain.
Check it yourselfClean and lube the chain, and check whether the derailleur has been bent in a fall. Don’t adjust the gears „by eye”, as you could easily turn the wrong screw.
What we doWe adjust the drivetrain and gears and, if needed, straighten the derailleur hanger (the frame dropout tab the derailleur attaches to), or replace the cable, housing or derailleur. More on the gear adjustment and chain replacement page.
048 €
Chain skips or slips under pedalling
WhyA stretched chain, or a worn cassette or sprockets. A new chain on a worn cassette often slips.
Check it yourselfFor chain stretch, please contact a workshop.
What we doWe replace the chain and adjust the gears. If the cassette or sprockets are worn, we tell you up front.
055–10 €
Punctured tyre or wheel losing air on its own
WhyMost often a punctured inner tube, a sharp object in the tyre, or a worn valve. An old tyre can also develop cracks.
Check it yourselfCheck the pressure and carefully run your fingers along the inside of the tyre to see whether a thorn or piece of glass is stuck in it. Pressure recommendations are in the tyre pressure chart.
What we doWe replace the tyre or inner tube and check the rim tape. In season, we do urgent tyre replacements right away. More on the wheel repair page.
068–15 €
Wheel wobbles sideways or rubs on the brakes
WhyAfter a pothole or a fall, the rim bends or the spokes loosen. A wheel that is badly out of true rubs on the brake pads.
Check it yourselfLift the bike and spin the wheel – you’ll see where it wobbles. Don’t adjust the spokes yourself – leave that to the workshop.
What we doWe true the wheel (8–15 €). Replacing the hub or rim costs 30 € excluding parts.
078–10 €
Wheel squeaks, has play or spins unevenly
WhyWheel bearings that are too loose or dried out, a damaged axle, or a worn freehub body.
Check it yourselfLift the bike and try pushing the wheel from side to side – if you feel play, the bearings are too loose.
What we doWe adjust the wheel bearings and, if necessary, replace the axle or service the freehub.
0825 €
Handlebar has play or headset rattles while riding
WhyLoose or worn headset bearings.
Check it yourselfSqueeze the front brake and rock the bike back and forth – if you feel a „clicking”, the headset needs attention.
What we doWe check and tighten the bearings; if there is damage, we replace the fork or headset.
09from 10 €
Internal gear hub bike won’t shift or slips
WhyMost often a poorly adjusted cable, or worn mechanisms inside the hub. A fault can also appear after a long period of non-use.
What we doWe inspect the hub and cable, adjust them, and if needed repair the internal gear hub.
10from 35 €
E-bike motor hums, squeaks or rolls with resistance
WhyThe motor’s mechanical bearings or gears may be worn. This is usually recognised by the noise.
What we doWe rebuild the motor and replace mechanical parts. We do not carry out electrical or electronics repair.